It reads as a flying saucer until the content goes on
From a distance this shape looks like a wide brim on a dark pedestal, which is why people call it a UFO, a trumpet or a horn depending on the day. The names are not important. What matters is the lip diameter, the throat diameter and the height between them — those three numbers decide everything downstream.
The green ring and white edge in the photo are the test pattern, not the finish. A flared surface shows banding and brightness steps far more readily than a flat wall, so a bright, flat field is what we run before anything artistic goes near it.
Every row is a different circumference
On a flat panel every horizontal row is the same width. Here the rim might be several times the circumference of the throat, so a module that fits neatly at the top cannot simply be repeated at the bottom. The surface is cut into rings, each ring with its own cabinet width and its own count, and the counts have to close exactly or the seam walks out of position by the time you reach the base.
That is the real reason a flared screen costs more per square metre than a flat one: it is not one module type bought in quantity, it is a short run of several different ones.
The lip is where the money sits
Because the widest ring holds the most pixels, most of the LED cost is in the top third of the shape. The narrow throat uses fewer modules by a wide margin, but it still needs the same control gear, the same cabling discipline and a frame stiff enough to hold the whole brim level.
If a budget has to come down, shrinking the lip diameter by a little saves more than shortening the pedestal does. We would rather tell you that at quotation stage than discover it after the steel is cut.
Content has to know it is a cone
A normal 16:9 video dropped onto this screen will bunch up at the throat and smear around the lip. Content for a flared display is mapped to the unwrapped surface — effectively a shape that is wide at one end and narrow at the other — and the artwork is drawn with that taper in mind.
In practice that means simple, bold marks near the rim where the surface is moving fastest past the viewer, and fine detail nearer the middle where people can actually read it. Logos at the top, text in the middle is a good starting rule.
Why it is standing on the floor and not a plinth
The unit in the photo is on a temporary frame in the test bay. The permanent base has not been made yet; what you are seeing is the screen being checked for brightness steps, ring alignment and hanging height while we still have room to adjust it.
Once it passes, it comes apart into numbered rings for packing. The base drawing is issued separately so the site can pour or bolt its foundation while the screen is in transit.
When this shape earns its keep
A flared screen works where you want an object rather than a sign — a lobby centre feature, an exhibition stand that has to be seen from across a hall, or a brand installation where the silhouette matters as much as the picture. It is a poor choice for a boardroom or anywhere people need to read a slide.
If the brief is really about readable information, say so early and we will steer you to a panel that does that job. If it is about being remembered, this is the shape that does it.

