It played. That was the problem.

A client sent a thirty-second clip last month and asked whether we could just play it on an 800 mm barrel. We could. We did. He watched it turn once, then asked why his logo looked wide.

Nothing was broken. The clip was 1920 x 1080, the screen is 1356 x 806, and someone on his side had stretched one to fit the other. A 5.8 percent squeeze you would never notice on a monitor is very obvious on a face. This is the part of a can screen project that gets planned last and causes the most rework, so here is what the file actually has to be.

What the barrel wants is a strip, not a frame

An 800 mm barrel has a circumference of 2,513 mm and a screen height of 1,500 mm. Unroll it and you get a 2,513 x 1,500 mm rectangle — an aspect ratio of 1.675:1. At P1.86 that is 1,356 columns by 806 rows, 1,092,936 lit pixels.

16:9 is 1.778:1. Close enough to look right in a design file, far enough to matter once it is wrapped. Either you letterbox and lose 300 mm of the circumference to black bars that rotate past the viewer every loop, or you stretch and pay for it in faces and circles. The third option, and the only one that looks professional, is to rebuild the layout at 1.675.

The left edge has to meet the right edge

On a flat wall a hard cut at the frame edge is invisible. On a barrel it is a vertical line that sweeps past the viewer every time the loop restarts. A three-second rotation shows it three times a minute.

So the artwork is a loop, not a sequence. Gradients have to arrive back at their starting value. Any motion that exits right has to enter left at the same height and speed. Text that crosses the join needs its baseline matched to the pixel, because a 2 mm step at the join reads as a crack once it is three metres wide in front of you. Ask your designer to preview it as a tube, not as a rectangle — most design tools will do a polar wrap, and the ones that will not can be faked by tiling the strip three times side by side and looking at where the copies meet.

Two thirds of the design is never seen at once

Stand two metres from an 800 mm barrel and you see roughly 120 degrees of it. That is a third of the surface. The rest is curving away, foreshortened into nothing.

This changes where things go. A logo centred in the flat file sits at the point nearest the viewer, which means it is only fully visible to someone standing exactly in front — and a person walking past sees it sliding off the edge for most of their approach. Move the brand block to about 90 degrees off centre and it greets people as they come, then hands over to the product shot. Put the one thing you want remembered at the join and nobody will ever read it whole.

Twelve segments will cut your picture whether you plan for it or not

An 800 mm barrel is twelve segments at 30 degrees. Each joint is a cabinet edge plus a shadow gap, about 10 mm of dark line. Twelve of those eat 120 mm of a 2,513 mm circumference, so roughly 5 percent of your image sits under a seam.

The seams fall every 209 mm in the flat file — at 0, 209, 419 and so on. Faces, prices, QR codes and thin type should not land there. On the screen the seam is 3 degrees of arc, which at close range looks like a pencil line drawn down the picture; from across a mall it disappears. Design for the close-up and it will be fine at both distances.

Three doors into the screen, and when each one is the right door

Once the file is right, getting it in is the easy part — but the three ways in are not interchangeable, and picking the wrong one is how a launch day goes wrong.

USB is the one that always works. The player sits in the base drum behind a hatch held by two screws, and you copy the file to a stick formatted FAT32 — exFAT is not read by every player, and FAT32 will not take a single file over 4 GB, which matters if someone exports a 4K master. It is also the least pleasant to use, because changing content means kneeling on a mall floor with a screwdriver.

Phone and network, and where each stops being enough

The phone route is what most single-unit buyers end up using. The barrel raises its own hotspot, you join it from the phone, and the app pushes the file over. Ten metres and line of sight is the practical range; through a wall it drops out. Good for one screen in a shop window, hopeless for twenty.

The network route is the one that scales. Cable the barrel to the venue switch, or drop a small 4G router in the base, and the screen becomes one node in a content management system. Twenty screens across twenty stores change together on a schedule, and nobody drives anywhere. If you are planning a rollout rather than a single unit, decide this before the base is built, because the network port and the mounting plate for the router have to exist in the drum. Retrofitting one means taking the base apart on site. When we quote a barrel we ask about this at the same time as the pixel pitch, since it changes what goes inside the drum.

Black is not black on a barrel in daylight

An indoor barrel runs at about 1,000 nits, an atrium unit at 1,500 or more. A design built on a monitor at #1A1A1A will read as roughly #3A3A3A under mall lighting, because the black you see is the black of the module face plus whatever the room bounces off it.

Two things fix it without touching the brightness: keep large flat black areas out of the layout, and put contrast in the content instead of the background — light type on a mid-tone field, or a lit product cut-out on a dark field with a rim glow. A barrel that looks washed out in a bright atrium almost always has a design problem, not a screen problem.

Hand your designer these four numbers

Canvas 2,513 x 1,500 mm, aspect 1.675:1. Pixels 1,356 x 806 at P1.86. Twelve seams at 209 mm intervals, 10 mm wide — keep type and faces off them. Visible arc 120 degrees, so the money shot belongs off centre, not in the middle.

That is the whole brief. Everything else — pitch, cabinet count, whether the top is lit — is our side of the table. Get these four right and the first render on site looks like the render in the email, which is a lower bar than it sounds and one that a surprising number of projects miss.