It is a cylinder with two radius changes
A can or bottle display is a cylinder for most of its height, then the radius steps in at the shoulder and again at the neck. Each step changes the circumference, and the circumference is what decides how many modules fit in a row.
A straight cylinder is simple: circumference is π times the diameter, modules run around it, and the seam hides at the back. A can adds two transitions where the same module has to span a smaller circle, and that is where the engineering, and the cost, moves.
The module count comes from the circumference
Take a 0.8 m diameter can. The circumference is about 2.51 m. With 250 mm modules you get ten across, with roughly 10 mm left over for the seams — workable. Push the diameter to 1.2 m and the circumference is 3.77 m, so you need fifteen modules, and the seam gaps change.
This is why making it a bit bigger is not a small change. Every diameter increase adds modules around the whole body, and the frame, power and data runs grow with it. The height matters too, but the diameter is the number that moves the price in steps.
Why the shoulder and neck cost the most
On the shoulder the radius shrinks, so the same module now wraps a tighter curve. Either the module is cut and re-pitched, or a smaller module is used for that band. Both mean a custom part that exists only on your screen, and custom parts are where the labour is.
The neck is worse: it is small, curved in two directions, and often needs a narrower module than the body. Some designs solve it by making the top a solid cap with a printed label rather than pixels. That is a legitimate choice, and it is much cheaper — but it is a design decision, not a default.
Pitch on a can is a compromise
On a flat wall you pick pitch by viewing distance. On a can you also fight the curve: a coarse pitch reads as facets up close, and a fine pitch costs more modules around a larger circumference. Most cans land at P2.5 to P4 for indoor work.
The practical rule is to set the pitch from the closest point a person can stand, then accept that the far side of the curve will look finer than it needs to. Trying to make the whole circumference perfect for one distance is how a can screen doubles in price for no visible gain.
Content is a wrap, not a video
A can is not a flat screen showing a video; it is a 360 degree strip. The file has to be authored as a wrap — the left edge meets the right edge, and the top and bottom bands map to the shoulder and base. A normal 16:9 video stretched around it will look wrong at the seam and squashed at the curve.
The cheaper alternative is to treat it as a rotating poster: one image, mapped to the cylinder, with the seam at the back. Many retail cans do exactly this, and it looks better than a video that was never designed for the shape.
What decides the price, in order
Diameter first, because it sets the module count. Height second, because it sets the rows. Then the shoulder and neck treatment — solid cap versus pixel band — which can swing the price more than either dimension. Pitch and control come last.
If a quote for two cans of the same height differs a lot, check the diameter and the top treatment before you check anything else. Those two explain most of the gap; the rest is usually freight and spares.
What to send us for a can quote
Send the diameter, the overall height, the height where the shoulder starts, and whether the top should be pixels or a printed cap. A photo of the product the can is modelled on helps more than a drawing, because it shows the proportions you actually want.
With those four numbers we can come back with a module count, a pitch recommendation and a price that separates body, shoulder and cap — so you can see what the shape costs before you commit to it.

